This item is temporarily out of stock. Please check back in a week or sign up to be notified when it is back in stock.
This hardware kit is required to stack your Reef drawers tightly while minimizing the overall height.
BE SURE TO CHECK YOUR RIG WILL ACCOMMODATE 2 DRAWERS FIRST. By this we mean measure from your vehicle tailgate back 41" (for Reef40) or 36" (for Reef35), then UP 21" and check if that will hit your seat. If it does a little and you are up for CIY2, then you can trim to fit.
These can be secured with an optional anchor plate, the included straps, or the optional ratchet straps. If you will be loading a lot of weight on top that could shift while driving we recommend the ratchet straps in back, secure to the top section.
Requires locating your drawer latch for the top drawer up top which might interfere with some folks' loadout so also including an optional small swing latch (in photo, top left)
The Sandbar cutting board will work with both levels.
It is possible to run 2 drawers side-by-side below, and another drawer up top via High Tide. It may even be possible (if you have enough room) to run 3 tall, although this has not yet been tested so proceed at your own risk! (and please ratchet it all down tightly if you do try)